Victory Reach-In Manual de Serviço Página 72

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 92
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 71
Section 7Diagnostics
7-4
Component Function/Specifications/Check Procedures
Main On/Off Switch
FUNCTION
Switches power to the reach-in on and off.
SPECIFICATIONS
Double pole single throw (DPST)
CHECK PROCEDURES
1. Check for proper line voltage (+/- 10%).
2. Inspect the switch for proper wiring.
3. Inspect the terminals for clean, tight
connections.
4. Check across the switch terminals with a
voltmeter. Replace the switch if you do
not obtain the results below:
Switch Position Voltage
On 0
Off line
Relay (if applicable)
FUNCTION
De-energizes the compressor if the high
pressure cut-out switch were to open
CHECK PROCEDURES
1. Disconnect power to the reach-in.
2. Disconnect wires from the relay and check
continuity at the terminals . Replace the
relay if you do not obtain the results
below:
Terminals Continuity
4 and 6 (contact
normally open)
no
0-1 (coil) yes
Temperature Control
FUNCTION
Opens and closes to start and stop the
compressor and condenser fan(s) to maintain
a constant cabinet temperature.
SPECIFICATIONS
Refrigerator
12° to 45° 16° differential
Freezer
-20° to +10° 10° Differential
CHECK PROCEDURES
If the reach-in continues to run in the cooling
cycle:
1. Turn the temperature control to the
warmest setting.
2. Hook a voltmeter across the temperature
control terminal leads.
3. If the voltmeter reads line voltage, the
control has opened and is functioning
normally. If the control fails to open,
replace it.
If the reach-in does not run:
1. Disconnect electrical power supply.
2. Turn the temperature control to the coldest
setting.
3. Isolate the temperature control and hook
an ohmmeter across the terminals.
4. If the ohmmeter registers continuity, the
control is good. See Service Diagnostic
Chart, “Reach-In Does Not Run” on page
7-1. If there is no continuity, replace the
control. See next page.
Vista de página 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 91 92

Comentários a estes Manuais

Sem comentários